Jane Zhang Posted May 20, 2020 Share Posted May 20, 2020 Hello, I made a cross table for a source table (Table1). I would like to switch the data table to Table2. When I did this by opening the visualization property and change the Data Table name in the drop down list, the cross table was wiped out, and I have to go through the same process of selecting the axes again. Is there a way that I could switch the source table while keeping the construction of the cross table Thank you very much Jan Link to comment Share on other sites More sharing options...
Manoj Singh Posted May 22, 2020 Share Posted May 22, 2020 The behavior had been improved from Spotfire 7.11 version but if still, you are facing any issue you can vote for the below enhancement feature request:https://ideas.tibco.com/ideas/TS-I-5574 Also, it would be great to specify your Spotfire version as well as detailed information on your requirements in the comment section of the above feature request. Link to comment Share on other sites More sharing options...
Jane Zhang Posted May 23, 2020 Author Share Posted May 23, 2020 Hi Manoj, Thank you for your advice. I am using 7.11.1.0.25. Link to comment Share on other sites More sharing options...
Manoj Singh Posted May 25, 2020 Share Posted May 25, 2020 Little improvement in the 7.11 version but still a lot of improvement is required. So vote for the shared enhancement feature request. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now