Errors when using the Anomaly Detection template version 5.0.0

[Hideo Sato]

I am currently verifying the Anomaly Detection template version 5.0.0 downloaded from the following URL, but I am encountering a error.

The data used, settings, etc. are left as default.

URL:https://community.spotfire.com/s/exchange/aCv4z0000008OcACAU/anomaly-detection-template-for-spotfire

We apologize for the inconvenience and would appreciate your help.

(1)Logs are not displayed on the "Logs" page.

I was unable to install the "logging" package on Spotfire in the first place, so I installed "logging2" instead, but this may be the cause of the problem.

Can you please help us to get this page to work properly?

I am attaching a screenshot of the "Logs" page not displaying due to an error and a screenshot of the "logging" package installation error.

We apologize for any inconvenience this may cause and thank you in advance for your patience.

[David Katz]

Thanks for your question.

Note that logging is a built-in package and does not need to be installed.

Also, please check the table visualization for the log entries. You may need to add columns through its properties. You can right click and then select properties and then columns. Please let me know if this resolves your issue.

[Hideo Sato]

Thank you for your response!

We have confirmed that the content is displayed successfully!

Thank you very much for your prompt and courteous reply!