Is it possible to pass Filtered table to Data relationship operations

[Manoj Chaurasia]

Hello

I was doing Data ReleationShip->Linear Relation on a table in spotfire . It always take the data Table as a whole and the calculation is not reflecting the filtering I do on the filter panel.

What is the best way to get this done. I have seen that outlier filtering by Marking>>Filter Out works and such selection and removal reflects in the calculations. Is there any way to make the filtering from data panel work

[Fabian Duerr]

My experience is the complete opposite ;). Spotfire only takes filtered data for the data relationships. However, if your are working with different filtering schemes, this can become confusing, because you are not asked which filtering scheme should be applied (at least not in 10.10.). To ensure you get the correct filtered data, navigate to a page where your filtering scheme of choice is active. Then start the data relationship tool.