Jump to content

3D Combined Surface and Line Chart Mod (Light) for Spotfire® 1.1.1 (Spotfire 11.5 LTS+)


1 Screenshot

Summary

Display surfaces and lines in one 3D graph

image.thumb.png.5d9511d739a28289512bc019f25df79a.png

The 3D Combined Surface and Line Chart Mod (Light) is used to draw 3D representations of various structures. It has applicability in the oil & gas industry to help visualize formations and wellbore trajectories in three dimensions. It helps in planning drilling and completions activities.


Try this Mod

image.thumb.png.381fad2e60ab1a13c6481e8c836e15f9.png

Spotfire® Analyst

Download this mod and follow the instructions below to open the mod in Spotfire Analyst:

  1. Open Spotfire® Analyst, and create an analysis by loading some data.
  2. Drag the downloaded .mod file into the analysis.
  3. The visualization mod is added to the analysis.
  4. To learn more about the capabilities and limitations of this visualization mod, read the user guide located in the downloaded folder.

For general information on how to use and share visualization mods, read the Spotfire documentation.


Data Requirement

The 3D Combined Surface and Line Chart Mod (Light) will draw surfaces and lines in a three dimensional space. To do this, spatial data must be provided and pre-computed where necessary.

Lines will generally plot with specified x, y, z co-ordinates as expected. But there are special requirements for surface data, due to constraints in the underlying Plotly library.

For detailed information on data requirements, the available settings, and an example of how to set up the list, read the mod's community article.


Help & Support

This Mod for Spotfire® is not supported by Spotfire Support.

For general questions about Mods, please post a question in the Forum for Extensions & Mods.

1.1.1 (Spotfire 11.5 LTS and later)
October 2024
Initial release


×
×
  • Create New...